|Step 3- Installation
||Place your new TrimParts molded carpet in the vehicle by centering it on the transmission tunnel and working towards the sides. Match the contours of the carpet with the floor; be sure the heel pad is under the area for the gas pedal.|
After confirming the proper fit, start the required cutouts as you fit the carpet to the vehicle. Note, it is better to start with a small slit in the carpet just large enough to fit over the object, then enlarge the opening only as much as required. Do Not Over Cut !
After the correct fit is determined, fold back a section of carpet, apply adhesive, and press back down to the floor. (Tip:Using a common automotive spray adhesive will give a smoother fit, and less likely to move over time.) Slip the carpet under the kick panels, door posts, and any valance if present, trim the excess that has been provided to allow for a perfect fit into your car.
Replace back seat, kick panels, consoles, seat belts, front seats, and sill plates (caution should be taken when reapplying any screws not to catch or snag the carpet.)
CONGRATULATIONS! You have successfully installed another Quality Product from TrimParts.