Have a Question, 801-546-3274 or email
55-57 Chevy Cut Pile
Molded Carpet Jade Green.
It is made by Trim
Parts, the best in the industry. This is a CUT PILE JADE GREEN
carpet. What makes this carpet so nice is that
it is custom molded to fit your floor. The maker uses
original floorplans to mold the carpet for the perfect fit. This will
fit all 55-57 models. Let me know the year and body style of your car and it
will be made to fit. I drop ship them directly from the factory. They
are made to order and take 10-14 days to arrive at your doorstep. See
below for installation instructions, very easy to install. I also have other
Step 1- Removal
Remove your new TrimParts molded
carpet from the box, unroll and lay the carpet in a warm area and allow it to
settle for one to two hours before attempting to install. (This will allow
the carpet to regain its molded shape.)
Remove sill plates (metal strip holding carpet at the threshold of
the door). Be sure to keep the screws.
Remove the front seats and seat tracks by removing the floor bolts in the
seat tracks. Be sure to check for and disconnect any electrical connections.
Remove rear seat cushions and center console if applicable.
Remove seat belt bolts if they are mounted in the carpet area.
It may be required to remove or loosen the kick panels and other moldings to
remove the old carpet.
Remove the old carpet, KEEP IT! do not discard the old
Step 2- Preparation
Remove the old padding, leave the
body insulation on the floor (do not remove the catalytic converter shield if
the vehicle has one on the floor)
Vacuum or sweep the floor, remove all loose matter
Place the old carpet over your new TrimParts molded carpet. Mark any holes or
additional cutout on the carpet with chalk, Do Not Cut Yet!
Step 3- Installation
Place your new TrimParts molded
carpet in the vehicle by centering it on the transmission tunnel and working
towards the sides. Match the contours of the carpet with the floor; be sure
the heel pad is under the area for the gas pedal.
After confirming the proper fit, start the required cutouts as you fit the
carpet to the vehicle. Note, it is better to start with a small slit in the
carpet just large enough to fit over the object, then enlarge the opening
only as much as required. Do Not Over Cut!
After the correct fit is determined, fold back a section of carpet, apply
adhesive, and press back down to the floor. (Tip: Using a common automotive
spray adhesive will give a smoother fit, and less likely to move over time.)
Slip the carpet under the kick panels, door posts, and any valance if
present, trim the excess that has been provided to allow for a perfect fit
into your car.
Replace back seat, kick panels, consoles, seat belts, front seats, and sill
plates (caution should be taken when reapplying any screws not to catch or
snag the carpet.)
CONGRATULATIONS! You have successfully installed another Quality
Product from TrimParts.